SELLING POINT DESCRIPTIONS
Laser marker (Only the Model C 8FSHE)
Use the laser marker for aligning with the ink line on the workpiece.
(1)Cutting position can be properly adjusted by aligning the positioning ink line with the laser line. There is no need to make a long ink line on the workpiece.
(2)There is no need to lower the motor head to align with the ink line because the laser marker makes a laser line on the workpiece. In addition, cutting position can be easily adjusted because the operator can hold the workpiece with both hands to move.
(3)Cutting position can be easily adjusted because the laser line can be aligned with an optionally angled ink line.
(4)Even the workpieces such as crown moldings and base boards that have decorative surfaces and are difficult to be made an ink line can be cut just by aligning the laser line with the ink line on the fence side. The laser line is adjusted to the width of the saw blade at the time of factory shipment. Depending upon the user's cutting choice, the laser line can be aligned with the left side of the cutting width (saw blade) or the ink line on the right side. Adjust the position of the laser line according to "Position adjustment of laser line" on page 17.
LED light (Only the Model C 8FSHE)
The Model C 8FSHE is equipped with an LED light to light up over a table brightly. The two LEDs incorporated in it light up the materials and the point of the saw blade brightly. The LED light can freely move at the time of right and left bevel cutting because the support is flexible. Therefore, it lights up the materials and the point of the saw blade brightly at any time.
Fig.
Laser beam
Laser marker
Fig.
Fig.
(molding, base board, etc.)
Fig. 2
Lightweight
The Model C 8FSE is most lightweight (14 kg) in the class of 8” (216 mm) slide compound miter saws because the reinforcement rib of the table is placed in the most suitable position.