Hitachi C 8FSHE, C 8FSE specifications

Page 45

of the laser line. (Repeat this operation 3 or 4 times depending on the adjusting conditions of the laser marker.) Refer to the above "(1) Construction of laser marker and functions of each component" for the relation between the two Seal Lock Hex. Socket Set Screws M5 x 6 [103] and the laser line.

4)To check the accuracy of the Laser Marker [107], move the Laser Marker [107] horizontally using the Adjuster [88] again and check that the laser beam is applied to the entire cutting surface. If the laser beam is applied to the cutting surface in parallel, the fine fuzz reflects the laser beam and the entire cutting surface becomes bright.

5)Make a right-angle ink line on the workpieces of 20 mm (13/16") in height and 150 mm (5-15/16") in width and 60 mm (2-3/8") in height and 150 mm (5-15/16") in width respectively. Adjust the laser marker and perform cutting. If the ink line matches the cutting position, the accuracy adjustment is completed. (Visually check that the laser marker accuracy is 0.35/100 or less for both the squareness with the base surface and the squareness with the fence surface.)

Fig. 58-c

-42-

Image 45

Contents Models C 8FSE, C 8FSHE Remark Contents Laser marker Only the Model C 8FSHE Selling Point DescriptionsPositive angle stoppers Slide cutting Miter cutting Compound miter and bevel cutting Specifications Specifications· 216 mm 8-1/2 TCT saw blade 15.9 mm 5/8 bore, NT24 Specification comparisons Comparisons with Similar ProductsFor Europe and others Except for the U.S.A and Canada C8FSE/C8FSHE 8FB2 Right angle For the U.S.A and CanadaFull-load current a 9.2 a Safety instructions Precautions in Sales PromotionPage Laser marker only the Model C 8FSHE Relative standardsAmbient illuminance and visibility of laser line Precautions concerning brakeAdjustment and Operational Precautions Confirmation for use of sub fence Optional accessoryConfirmation of saw blade lower limit position Position adjustment of laser line Only the Model C 8FSHE Adjustment of table insert position How to use the vise assemblyCutting operation Page Bevel scale Clamp lever Tighten Crown molding stopper R Page Adjustment of Components Bevel angle adjustmentBall bushing Linear bearing Packing Precautions in disassembly and reassembly Repair GuideTurn table and base assy Page Then remove the Lower Guard 215 from the Bearing Holder Lower guard, link, spindle assy and dust guidePage Armature assy and lock lever Page Vise ass’y Laser markerSpecial attention ReassemblyWiring diagram Page Page Page Reassembly requiring adjustment Checking of insulation distanceNo-load current Product precision LubricationAdjustment of laser marker accuracy Page Page 211 Troubleshooting guideBushing 115 and slide Page 160 107 8FSHE Standard Repair Time Unit Schedules8FSE Slide Compound SAW 8FSHE 501 Parts SUB Fence For USA, can Nylon Clip Ball Bearing 608VVC2PS2L Standard Accessories Model C 8FSE 8FSE 162 153 152 8FSE Scale a For USA, can Carbon Brush 1 Pair For GBR 110V, USA, CAN, VEN, TPE Lock Lever Spring Includ 626