Hitachi C 8FSE, C 8FSHE specifications

Page 26

WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown molding might be thrust from the table and cause bodily harm.

Do not perform bevel cutting. The main body or the saw blade may contact the sub fence, resulting in an injury.

CAUTION: Always confirm that the motor head does not contact the crown molding vise ass’y when it is lowered for cutting. If there is any danger that it may do so, loosen the 6 mm knob bolt and move the crown molding vise ass’y to a position where it will not contact the saw blade.

Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT EDGE against the crown molding stoppers as shown in Fig. 32-b. Adjust the crown molding stoppers according to the size of the crown molding. Tighten the 6 mm wing bolt to secure the crown molding stoppers. Refer to the following table for the miter angle.

Table 9

		Position in Fig. 26	Miter angle	Finished piece
	For inside corner	1	Right 45°	Save the right side of blade
		2	Left 45°	Save the left side of blade
	For outside corner	3	Left 45°	Save the right side of blade
	For outside corner	3		Save the right side of blade
		4	Right 45°	Save the left side of blade

-23-

Image 26

Contents Models C 8FSE, C 8FSHE Remark Contents Selling Point Descriptions Laser marker Only the Model C 8FSHEPositive angle stoppers Slide cutting Miter cutting Compound miter and bevel cutting Specifications Specifications· 216 mm 8-1/2 TCT saw blade 15.9 mm 5/8 bore, NT24 For Europe and others Except for the U.S.A and Canada Specification comparisonsComparisons with Similar Products C8FSE/C8FSHE For the U.S.A and Canada 8FB2 Right angleFull-load current a 9.2 a Precautions in Sales Promotion Safety instructionsPage Relative standards Laser marker only the Model C 8FSHEPrecautions concerning brake Ambient illuminance and visibility of laser lineConfirmation of saw blade lower limit position Adjustment and Operational PrecautionsConfirmation for use of sub fence Optional accessory Position adjustment of laser line Only the Model C 8FSHE How to use the vise assembly Adjustment of table insert positionCutting operation Page Bevel scale Clamp lever Tighten Crown molding stopper R Page Ball bushing Linear bearing Adjustment of ComponentsBevel angle adjustment Packing Turn table and base assy Precautions in disassembly and reassemblyRepair Guide Page Lower guard, link, spindle assy and dust guide Then remove the Lower Guard 215 from the Bearing HolderPage Armature assy and lock lever Page Laser marker Vise ass’yReassembly Special attentionWiring diagram Page Page Page No-load current Reassembly requiring adjustmentChecking of insulation distance Lubrication Product precisionAdjustment of laser marker accuracy Page Page Troubleshooting guide 211Bushing 115 and slide Page 160 107 Standard Repair Time Unit Schedules 8FSHE8FSE Slide Compound SAW 8FSHE 501 Parts SUB Fence For USA, can Nylon Clip Ball Bearing 608VVC2PS2L Standard Accessories Model C 8FSE 8FSE 162 153 152 8FSE Scale a For USA, can Carbon Brush 1 Pair For GBR 110V, USA, CAN, VEN, TPE Lock Lever Spring Includ 626