English
(2)For the hard material, such as a steel plate, etc., decrease the orbital operation. For the soft material, such as lumber, plastic, etc., increase the orbital operation to increase work efficiency. To cut the material accurately, decrease the orbital operation.
9.Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using No. 97 blade. Carefully read “Concerning cutting of stainless steel plates” for proper operation.
Change knob
Fig. 7
10.Splinter guard
Using the splinter guard when cutting wood materials will reduce splintering of cut surfaces.
Insert the splinter guard in the space on the base, and push it completely. (see Fig. 8)
11.Chip cover
Chip cover prevents chips from flying off and improves the efficiency of dust collector. Insert the chip cover between the base and lever, and push with a slight pressure until it catches in place. (Fig. 9)
When removing chip cover, hold both sides of knob and slightly open until it can be removed from the Jig Saw. (Fig. 10)
NOTE: There is a possibility that chip cover is frosted when cutting the metal.
12.Sub base
Using the sub base (made from steel) will reduce abrasion of aluminium base especially in cutting metals.
Using the sub base (made from resin) will reduce scratching of cut surface. Attach the sub base to the bottom surface of base by attached 4 screws.
Splinter guard
Base
Fig. 8
Lever
Chip cover
Base
Fig. 9
Chip cover
Fig. 10
12