1.Make sure that the UPS is properly installed and secured with its leveling feet.
2.Roll the battery cabinet to a spot near the
3.The field kit is attached with cable ties to the frame inside the door. Remove and retain the field kit for later use.
4.If necessary, remove the cosmetic covers and hanger brackets from the
5.Push the battery cabinet toward the UPS cabinet until the doors are flush with each other.
6.Three cabinet attachment brackets are provided for securing each cabinet at the top and bottom. Two flat brackets join the tops of the cabinets, one at the front and one at the back. A larger flat bracket joins the cabinets at the bottom. Attach the flat brackets to the cabinet tops first.
7.For Series 685 Battery Cabinets, remove the
8.For Series 1085 Battery Cabinets, remove the
9.Align the holes in the other small flat bracket with the two holes in the top rear of the UPS and the battery cabinet. Attach each end to its mating hole using an M4×10 hex screw from the field kit (see Figure 7).
NOTE: Perform Steps 10 through 13 for the Series 1085 Battery Cabinet. Perform Steps 14 through 18 for the Series 685 Battery Cabinet.
10.Locate the large flat bracket from the field kit. Place one end of the bracket over the stud on the bottom side of the UPS cabinet lower
11.Attach the bracket to the hinges with two M8
12 | Powerware 9350 Series 685 and 1085 Auxiliary Battery Cabinets |
| Installation Manual 164201408 Rev. P00 053002 |