Multiquip HTXD6i / STXD6i manual Initial Check and Adjustments, OIL and Coolant Check

Page 13

INITIAL CHECK AND ADJUSTMENTS

PRELIMINARY CHARGE PRESSURE ADJUSTMENT

NOTICE

Skipping this step during initial set-up may cause machine to inadvertently move during further steps, due to insufficient charge pressure.

1.Loosen 1-1/16" jam nut on charge relief valve (Item A, Figure 5).

2.Use a 1/2" socket to adjust the small hex nut within the larger hex jam nut (Item B, Figure 5).

3.Rotate small hex nut (Item B, Figure 5) clockwise until bottomed out. DO NOT overtighten.

OIL AND COOLANT CHECK

Hydraulic Oil Check

1.Make sure the machine is cold.

2.Remove the starwheel cap (Figure 6) and visually check oil level.

3.Make sure that it is filled to the red line as shown in Figure 6.

4.Put back and tighten starwheel cap after checking or filling.

NOTICE

The sight glass is only used to check the fluid condition (dirt or air bubbles) and not to check the oil level.

A

B

REMOVE STARWHEEL CAP TO CHECK OIL LEVEL

Figure 5. Preliminary Charge Pressure

AdjustmentOIL LEVEL FLUID CONDITION (FULL) SIGHT GLASS

Figure 6. Oil Level Check

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 13

Image 13
Contents This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6iHTX6Di/STX6Di Trowel Table of ContentsMachine Information and Maintenance LOG Safety Messages Safety Information„ALWAYS know the location of the nearest General SafetyEngine Safety Trowel SafetyOrder Form PT-160 Before servicing equipmentBattery Safety Fuel Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the batteryTowing Safety Transporting SafetyLifting „ Always shutdown engine before transportingEnvironmental Safety Tools Needed Model Machine InformationSerial Number Setup Jumper Installation General ProceduresRemove Setup Jumper If installed OIL and Coolant Check Initial Check and AdjustmentsHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, FigureEngine Coolant Engine OilEnsure engine is level Click Cancel again when the new screen comes up Service Tool Setup and ConnectionWST Tool Bar Input the license key obtained from Multiquip and click OKConnection Procedure Laptop ConfigurationClick Finish on the next screen to complete installation Necessary to crank or turn on the engineSensor Adjustment Machine Setup and CalibrationCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame FigureCalibration Secondary Hydraulic Fill ProceduresPress Start button to begin calibration and follow prompts Charge Pressure Adjustment Machine Pressure AdjustmentPitch Pressure Check Restart machineSteering Pressure Adjustment Pitch Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Adjust Zero Stroke Position Trowel Speed ADJUSTMENT\SETUPLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, FigureRemove setup jumper or re-enable stroke follower Right Side Trowel Speed AdjustmentCalibrate Stroke Sensor Flatten Blades Pitch SetupMeasure Blade Leading Edge Height Leading Edge Height AdjustmentPitch Sensor Calibration Set Zero Pitch Cylinder StopsTurn machine off for 10 seconds GaugeFluid Levels InspectionMechanical Static Blade Pitch Drift Test Switch smart pitch switch to off positionRefer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help