Multiquip HTXD6i / STXD6i manual Safety Information, Safety Messages

Page 4

SAFETY INFORMATION

Do not operate or service the equipment before reading the entire manual. Safety precautions should be followed at all times when operating this equipment.

Failure to read and understand the safety messages and operating instructions could result in injury to yourself and others.

SAFETY MESSAGES

The four safety messages shown below will inform you about potential hazards that could injure you or others.The safety messages specifi cally address the level of exposure to the operator and are preceded by one of four words: DANGER, WARNING, CAUTION or NOTICE.

SAFETY SYMBOLS

DANGER

Indicates a hazardous situation which, if not avoided, WILL result in DEATH or SERIOUS INJURY.

WARNING

Indicates a hazardous situation which, if not avoided, COULD result in DEATH or SERIOUS INJURY.

CAUTION

Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE INJURY.

NOTICE

Addresses practices not related to personal injury.

Potential hazards associated with the operation of this equipment will be referenced with hazard symbols which may appear throughout this manual in conjunction with safety messages.

Symbol

Safety Hazard

Lethal exhaust gas hazards

Explosive fuel hazards

Burn hazards

Rotating parts hazards

Pressurized fluid hazards

Hydraulic fluid hazards

PAGE 4 — HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14)

Image 4

Contents Model HTXD6i/STXD6i This Manual Must Accompany the Equipment AT ALL TimesTable of Contents HTX6Di/STX6Di TrowelMachine Information and Maintenance LOG Safety Information Safety MessagesGeneral Safety „ALWAYS know the location of the nearestTrowel Safety Engine SafetyOrder Form PT-160 Before servicing equipmentFuel Safety Battery Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the batteryTransporting Safety Towing SafetyLifting „ Always shutdown engine before transportingEnvironmental Safety Tools Needed Model Machine InformationSerial Number Setup Jumper Installation General ProceduresRemove Setup Jumper If installed Initial Check and Adjustments OIL and Coolant CheckHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, FigureEngine Coolant Engine OilEnsure engine is level Service Tool Setup and Connection Click Cancel again when the new screen comes upInput the license key obtained from Multiquip and click OK WST Tool BarLaptop Configuration Connection ProcedureClick Finish on the next screen to complete installation Necessary to crank or turn on the engineMachine Setup and Calibration Sensor AdjustmentCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame FigureCalibration Secondary Hydraulic Fill ProceduresPress Start button to begin calibration and follow prompts Machine Pressure Adjustment Charge Pressure AdjustmentPitch Pressure Check Restart machineSteering Pressure Adjustment Pitch Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Trowel Speed ADJUSTMENT\SETUP Adjust Zero Stroke PositionLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, FigureRemove setup jumper or re-enable stroke follower Right Side Trowel Speed AdjustmentCalibrate Stroke Sensor Pitch Setup Flatten BladesLeading Edge Height Adjustment Measure Blade Leading Edge HeightSet Zero Pitch Cylinder Stops Pitch Sensor CalibrationGauge Turn machine off for 10 secondsFluid Levels InspectionMechanical Switch smart pitch switch to off position Static Blade Pitch Drift TestFuse Information Refer to for location on fuse panelPage HERE’S HOW to GET Help