Multiquip HTXD6i / STXD6i manual Environmental Safety

Page 9

SAFETY INFORMATION

„Trailer should be adjusted to a level position at all times when towing.

„Raise and lock trailer wheel stand in up position when towing.

„Place chock blocks underneath wheel to prevent rolling while parked.

„Place support blocks underneath the trailer’s bumper to prevent tipping while parked.

„Use the trailer’s swivel jack to adjust the trailer height to a level position while parked.

ENVIRONMENTAL SAFETY

NOTICE

„Dispose of hazardous waste properly. Examples of potentially hazardous waste are used motor oil, fuel and fuel fi lters.

„DO NOT use food or plastic containers to dispose of hazardous waste.

„DO NOT pour waste, oil or fuel directly onto the ground, down a drain or into any water source.

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 9

Image 9
Contents This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6iHTX6Di/STX6Di Trowel Table of ContentsMachine Information and Maintenance LOG Safety Messages Safety Information„ALWAYS know the location of the nearest General SafetyEngine Safety Trowel SafetyOrder Form PT-160 Before servicing equipmentBattery Safety Fuel Safety„ Never tamper with the factory settings „ Use well-insulated gloves when picking up the batteryTowing Safety Transporting SafetyLifting „ Always shutdown engine before transportingEnvironmental Safety Tools Needed Machine Information ModelSerial Number General Procedures Setup Jumper InstallationRemove Setup Jumper If installed OIL and Coolant Check Initial Check and AdjustmentsHydraulic Oil Check Loosen 1-1/16 jam nut on charge relief valve Item A, FigureEngine Oil Engine CoolantEnsure engine is level Click Cancel again when the new screen comes up Service Tool Setup and ConnectionWST Tool Bar Input the license key obtained from Multiquip and click OKConnection Procedure Laptop ConfigurationClick Finish on the next screen to complete installation Necessary to crank or turn on the engineSensor Adjustment Machine Setup and CalibrationCalibrate Foot Pedal Click Calibration button in Pedal Sensor frame FigureSecondary Hydraulic Fill Procedures CalibrationPress Start button to begin calibration and follow prompts Charge Pressure Adjustment Machine Pressure AdjustmentPitch Pressure Check Restart machinePitch Pressure Adjustment Steering Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Adjust Zero Stroke Position Trowel Speed ADJUSTMENT\SETUPLeft Side Trowel Speed Adjustment Lower trowel and shut off Loosen Jamb nut Item D, FigureRight Side Trowel Speed Adjustment Remove setup jumper or re-enable stroke followerCalibrate Stroke Sensor Flatten Blades Pitch SetupMeasure Blade Leading Edge Height Leading Edge Height AdjustmentPitch Sensor Calibration Set Zero Pitch Cylinder StopsTurn machine off for 10 seconds GaugeInspection Fluid LevelsMechanical Static Blade Pitch Drift Test Switch smart pitch switch to off positionRefer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help