Multiquip HTXD6i / STXD6i manual Pitch Pressure Adjustment, Steering Pressure Adjustment

MACHINE SETUP AND CALIBRATION

8.Return engine rpm to idle.

9.Turn off machine and remove gauge.

Pitch Pressure Adjustment

1. Disable cold start.

1.Increase engine rpm to full operating RPM.

2.Loosen 3/4" jam nut on pitch relief valve (Figure 29).

Steering Pressure Adjustment

NOTICE

DO NOT depress the foot pedal with the 300-600 PSI gauge installed. Immediate damage to the gauge will occur.

1.Disable cold start.

2.Install a 300 or 600 PSI gauge on steering pressure port (Figure 27).

3.Start machine.

4.Increase engine rpm to full operating RPM.

5.Loosen 3/4" jam nut on steering valve (Figure 30).

3/4-INCH

JAM NUT

1/4-INCH

HEX NUT STEERING VALVE

Figure 29. Pitch Pressure Adjustment

3.Using a 1/4" allen wrench, adjust the small hex nut within the larger hex jam nut.

4.Tighten 3/4" jam nut.

5.Check the pressure as described earlier (see Pitch Pressure Check section).

6.If pressure requires further adjustment, repeat steps 2 through 4 until pressure check reads 1850 ± 50 PSI.

7.Record pressure on Machine Information and Maintenance Log.

8.Return machine engine rpm to idle.

9.Turn off machine and remove gauge.

ADJUSTMENT

SCREW

Figure 30. Steering Pressure Adjustment

6.Using a 1/4" allen wrench, adjust the small hex nut within the larger hex jam nut.

7.Adjust to proper steering pressure:

• HTXD6i:

245 psi ± 10 psi (Cold Oil)

235 psi ± 10 psi (Hot Oil)

• STXD6i:

300 psi ± 10 psi (Cold Oil)

290 psi ± 10 psi (Hot Oil)

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 21