Multiquip HTXD6i / STXD6i manual

Page 31

NOTES

HTXD6i/STXD6i TROWEL • SETUP, ADJUSTMENTS AND CALIBRATIONS — REV. #1 (01/24/14) — PAGE 31

Image 31
Contents This Manual Must Accompany the Equipment AT ALL Times Model HTXD6i/STXD6iHTX6Di/STX6Di Trowel Table of ContentsMachine Information and Maintenance LOG Safety Messages Safety Information„ALWAYS know the location of the nearest General SafetyBefore servicing equipment Trowel SafetyEngine Safety Order Form PT-160„ Use well-insulated gloves when picking up the battery Fuel SafetyBattery Safety „ Never tamper with the factory settings„ Always shutdown engine before transporting Transporting SafetyTowing Safety LiftingEnvironmental Safety Tools Needed Model Machine InformationSerial Number Setup Jumper Installation General ProceduresRemove Setup Jumper If installed Loosen 1-1/16 jam nut on charge relief valve Item A, Figure Initial Check and AdjustmentsOIL and Coolant Check Hydraulic Oil CheckEngine Coolant Engine OilEnsure engine is level Click Cancel again when the new screen comes up Service Tool Setup and ConnectionWST Tool Bar Input the license key obtained from Multiquip and click OKNecessary to crank or turn on the engine Laptop ConfigurationConnection Procedure Click Finish on the next screen to complete installationClick Calibration button in Pedal Sensor frame Figure Machine Setup and CalibrationSensor Adjustment Calibrate Foot PedalCalibration Secondary Hydraulic Fill ProceduresPress Start button to begin calibration and follow prompts Restart machine Machine Pressure AdjustmentCharge Pressure Adjustment Pitch Pressure CheckSteering Pressure Adjustment Pitch Pressure AdjustmentReturn engine rpm to idle Turn off machine and remove gauge Lower trowel and shut off Loosen Jamb nut Item D, Figure Trowel Speed ADJUSTMENT\SETUPAdjust Zero Stroke Position Left Side Trowel Speed AdjustmentRemove setup jumper or re-enable stroke follower Right Side Trowel Speed AdjustmentCalibrate Stroke Sensor Flatten Blades Pitch SetupMeasure Blade Leading Edge Height Leading Edge Height AdjustmentPitch Sensor Calibration Set Zero Pitch Cylinder StopsTurn machine off for 10 seconds GaugeFluid Levels InspectionMechanical Static Blade Pitch Drift Test Switch smart pitch switch to off positionRefer to for location on fuse panel Fuse InformationPage HERE’S HOW to GET Help