Grizzly G0460/G0461 owner manual Rip Fence and Scale, To install the rip fence

Rip Fence and Scale

Components and Hardware Needed:	Qty
Rip Fence	1
Round Rail	1
Rip Fence Body	1
Square Tube w/Scale	1
Flat Washers 6mm (Scale/Table)	5
Hex Nuts M6-1 (Scale/Table)	5
Cap Screws M6-1 x 20 (Scale/Table)	5

The accuracy of the rip fence being parallel to the blade is dependent on the position of the round rail. The round rail is equipped with hex nuts on mounting studs to precisely adjust the position of the round rail when bringing the rip fence parallel to the blade.

To install the rip fence:

1.DISCONNECT SAW FROM POWER!

2.Remove a hex nut and a flat washer from each of the studs in the round rail.

3.Insert the studs into the table as shown in Figure 26, and loosely secure with the hex nuts and flat washers removed in Step 1.

Figure 26. Installing the round rail.

G0460/G0461 12" Sliding Table Saw

4.Align the square tube w/scale parallel with the top of the table and secure it with the five cap screws, flat washers, and hex nuts (see Figure 27).

Note: Two of the cap screws attach directly into the table without washers or hex nuts.

Stop

Screw

Figure 27. Attaching the scale.

5.Slide the rip fence body onto the rail and move it all the way to the left, until it stops against the stop screw at the end of the rail.

6.Adjust the nut shown in Figure 28 until the pinion gear teeth under the rip fence body mesh with the teeth on the square tube when the micro-adjust knob is pushed down. Tighten the hex nuts on that stud to secure the rail on that end.

Micro-Adjust

Knob

Nut

(on rail stud)

Figure 28. Aligning the round rail.

-23-