Scoring Blade
Most scoring blade sets consist of an inner and outer blade and internal shims. The shims are provided so the scoring blade thickness can be adjusted to match the kerf thickness of the main blade. The requirements for the G0460/G0461 scoring blade are an 80mm outside diameter with a 20mm arbor hole.
Components and Hardware Needed: | Qty |
Scoring Blade (Not Included) | 1 |
To install the scoring blade: |
|
1.DISCONNECT SAW FROM POWER!
2.Move the blade tilt to 0° (blade 90° to table) and lower the main blade all the way down.
3.Slide the table all the way forward to access the blade arbor, loosen the flange bolt secur- ing the lower blade guard, slide the flange bolt up, and pull open the lower blade guard.
4.Measure the thickness of the main blade (at the carbide tips). Use the shims that came with the scoring blade set (Figure 38) to stack the scoring blade to the same thickness as the main blade.
Figure 38. Typical scoring blade with shims.
G0460/G0461 12" Sliding Table Saw
5.Install the blade set with the teeth facing the opposite direction as the main blade, then re- install the arbor flange and the arbor nut.
6.Place a hex wrench in the hole in the arbor and use the arbor wrench to tighten the arbor nut as shown in Figure 39.
Note: The arbor nut has