Woodstock W1813 manual Zfdd\e\, 8aljkd\ekj, Gx\

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
('% Reset the emergency stop button, then turn the
sanding motor FE.
Efk\1K_\jXe[`e^dfkfidljkY\FE Y\]fi\k_\
Zfem\pfiZXeY\jkXik\[%
((% Turn the conveyor FE and verify that it operates
correctly—it should move from front-to-back. Use
the conveyor feed rate dial to vary the speed.
()% Turn the conveyor F==, then remove the switch dis-
abling key, as shown in =`^li\(,.
(*% Try to turn the conveyor FE.
— If the conveyor does not start, the switch disabling	=`^li\(,% Removing the switch disabling
		key from the conveyor ON/OFF switch.
feature is working as designed.
— If the conveyor does start, immediately stop the		I\Zfdd\e[\[
machine and disconnect it from power. The switch
safety feature must work properly before proceed-		8[aljkd\ekj
disabling feature is not working correctly. This
ing with the regular operations. Call Tech Support	For your convenience, the adjustments
for help.	listed below have been performed at the
(+% Press the emergency stop button to turn the sanding	factory and no further setup is required to
	operate your machine.
motor F==, re-install the switch disabling key, then
reset the emergency stop button.	However, because of the many variables
(,% Disconnect the compressed air source from the sand-	involved with shipping, some of these
	adjustments may need to be repeated to
er and attempt to turn the sanding motor FE.	ensure optimum results. Keep this in mind
— If the machine does not start, the air pressure	as you start to use your new machine.
safety switch is working correctly.	Step-by-step instructions for these adjust-
— If the machine does start (with the compressed air	ments can be found in the J<IM@:<section
	of this manual.
source disconnected from the machine), immedi-
ately turn the machine F== and disconnect it from	•	Conveyor Belt Tensioning (GX^\)0) &
power. The air pressure safety switch is not work-		Tracking (GX^\*').
ing correctly. This safety feature must work prop-
erly before proceeding with regular operations.	•	Gib Adjustment (GX^\*().
Call Tech Support for help.
(-%When all of the steps of the K\jkIleprocedure	• Sanding Drum & Conveyor Parallelism
		(GX^\*)).
have been successfully completed, your sander is
ready for operation.	• Air Pressure Safety Switch (GX^\*+).
	• Depth of Cut Safety Bar Height (GX^\
		*,).
	•	Pressure Roller Adjustment (GX^\*-).

-17-

J<KLG