Woodstock W1813 manual gkflkJX\kp9Xi, KffcjE\\\

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

;\gk_f]:lkJX]\kp9Xi

When properly adjusted, the depth of cut safety bar prevents the operator from sanding a workpiece that is beyond a safe height and that could become a kickback hazard.

The position of this safety bar (see =`^li\**) was set by the factory at approximately 0.047" (3⁄64") above the low- est point of the sanding drum. For safe operation, make sure that this safety bar remains at this setting.

KffcjE\\[\[	Hkp
Wrench 10mm	1
Feeler Gauge 0.047" (3⁄64")	1

KfX[aljkk_\[\gk_f]ZlkjX]\kpYXikfk_\]XZkfipj\k$ k`e^#[fk_\j\jk\gj1

(% Make sure the sanding drum and conveyor are paral- lel (refer to GX^\*) for detailed instructions).

)% Surface plane and sand an 18" wide piece of stock until it is flat and the same height from side-to-side.

*% DISCONNECT THE SANDER FROM POWER!

+% Open the sanding belt access door and remove the sanding belt from the machine.

5.Loosen the three hex bolts securing the safety bar (see =`^li\**), raise the bar up slightly, then tight- en the hex bolts enough to hold it in place.

-%Place the workpiece from Jk\g)under the sanding drum, then lower the sanding cabinet until the sand- ing drum is just touching the workpiece.

.% Remove the workpiece from under the sanding drum and position it directly under the depth of cut safety bar.

/% Loosen the three hex bolts securing the safety bar, then position the bar so that it is 0.047" (3⁄64") above the workpiece from side-to-side, then fully re-tight- en the hex bolts to secure it.

0% Re-install the sanding belt and secure the access door.

Hex Bolts

Safety Bar

=`^li\**% Depth of cut safety bar.

J<IM@:<

-35-