N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
*% Turn both adjustment bolts clockwise one full turn at a time until there is an approximate 3⁄4" hanging gap on the underside of the conveyor belt.
+% Take another reading of the reference measurement on both sides of the conveyor and make sure they are the same.
—If the belt starts to track to one side or the other when in operation, immediately turn the conveyor
F==Xe[g\i]fidk_\kiXZb`e^gifZ\[li\Y\cfn%
The conveyor roller assemblies and belt pose an entanglement hazard. Take extra care when performing the con- veyor belt tensioning or tracking proce- dures to keep hands, fingers, and cloth- ing away from the moving parts of the conveyor assembly.
J<IM@:<
:fem\pfi9\ckKiXZb`e^
If the conveyor belt tracks to either side, the belt could become damaged and you will have to replace it.
Adjusting conveyor belt tracking is a balancing process that takes patience and
KffcjE\\[\[ | Hkp |
Wrench 10mm | 1 |
KfX[aljkk_\Zfem\pfiY\ckkiXZb`e^#[fk_\j\jk\gj1
(% Make sure the conveyor belt is properly tensioned (refer to :fem\pfi9\ckK\ej`fe`e^on GX^\)0 for detailed instructions).
)% Turn the conveyor FE and set it to a slow feed rate, then watch it track.
*% Determine which side the conveyor belt is tracking toward, then tighten the adjustment bolt on that side until the belt begins to track in the opposite direction.
Efk\1KiXZb`e^Z_Xe^\jdXpkXb\XZflgc\f]d`e$ lk\jY\]fi\k_\pXi\efk`Z\XYc\%
+% When the conveyor belt is near the middle of the rollers, loosen the same adjustment bolt until the belt stops moving to the side and tracks straight and centered.
—If the belt tracks too far to the other side, tighten the adjustment bolt as necessary to bring it back toward the middle, then repeat Jk\gj)Æ+until the tracking is correct.