Woodstock W1813 manual `iI\lcXkfi&=`ck\i, KfclYi`ZXk\k\\c\mXk`fe\Xij#fk\j\jk\gj1

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

*% Clean away any debris and built-up grime from the surfaces of the ways, then apply a thin coat of ISO 68 lubricant or an equivalent.

+% Move the sanding cabinet through its entire elevation range of motion to evenly distribute the oil.

KffcjE\\[\[	Hkp
Hex Wrench 4mm	1
KfclYi`ZXk\k_\\c\mXk`fe^\Xij#[fk_\j\jk\gj1
(% DISCONNECT THE SANDER FROM POWER!

)% Loosen the set screw in the elevation handwheel hub, then remove the handwheel to access the ele- vation gears, as shown in =`^li\),.

*% Use a shop rag and solvent to clean away debris and grime from the gears, then use a brush to apply a thin coat of NLGI #2 grease or an equivalent.

+% Re-install the handwheel, then move the sanding cabinet up and down to evenly distribute the grease.

=`^li\),% Elevation gears (elevation

handwheel removed).

D8@EK<E8E:<

8`iI\^lcXkfi&=`ck\i

The air regulator filters the moisture from the incoming compressed air and deposits the collected water in the filter reservoir (see =`^li\)-).

To empty the filter reservoir, make sure there is incom- ing air pressure, then press the drain valve up. This will release a flow of air and the collected water from the reservoir.

Filter
	Drain
Reservoir	Valve

=`^li\)-%Air regulator filter reservoir

and drain valve.

-28-