Woodstock W1813 manual JXe`eFg\iXk`fe

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

JXe[`e^Fg\iXk`fe

Kfg\i]fidXkpg`ZXcjXe[`e^fg\iXk`fe#]fccfnk_\j\ jk\gj1

(% Read and follow the safety instructions at the begin- ning of the manual, and make sure the machine is set up properly before starting the sander.

)% Connect the source of compressed air to the sander and adjust the air regulator to 57–60 PSI.

*% Make sure the workpiece is clean and free of any defects or foreign materials that might cause kick- back or damage to the sander.

DO NOT sand more than one board at

atime side-by-side. Minor variations in workpiece thickness can cause one board to be propelled into the operator at a high rate of speed by the sanding belt and could result in serious personal injury.

+% Start the dust collection system.

,% Use the elevation handwheel to set the correct sand- ing depth of cut for the first pass (refer to ;\gk_f] :lk on GX^\)) for detailed instructions).

Efk\1>\e\iXccp#k_\]`ijkgXjji\dfm\jk_\_`^_ jgfkj%

-%Turn the sanding motor FE.

.% Turn the conveyor FE and correctly adjust the conveyor feed rate for your operation (refer to :fem\pfi=\\[IXk\on GX^\)( for detailed instructions).

/% Stand to the side of the sanding path, then firmly hold the workpiece and ease it into the sander at the same feed rate as the conveyor.

0% While standing to the side of the sanding path, let the conveyor feed the workpiece out of the sander and into your hands.

('% For additional passes, use the elevation handwheel to lower the sanding drum to the correct sanding depth of cut for your operation, which should not exceed 0.016" (1⁄16").

 Efk\1=finfibg`\Z\jn`[\ik_Xe(/Xe[le[\i*-# ifkXk\k_\jkfZb(/'—_fi`qfekXccpkfjXe[k_\fk_\i _Xc]%N\i\Zfdd\e[fm\icXgg`e^k_\jXe[`e^Xi\Xj ]fi^ff[i\jlckj%

-25-

FG<I8K@FEJ