Woodstock W1813 manual Fem\pfi=\\IXk, =`li\0

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

*% To release the tension on the sanding belt, move
the tension lever up and to the right out of the top				Top
catch, then use moderate force to push it down and				Catch
under the bottom catch, as shown in =`^li\(/.
+% Pull the sanding belt off the upper roller and the				Bottom
				Catch
sanding drum.
,% Slide the new sanding belt onto the upper roller and
sanding drum, then position it on the upper roller so
that it is just past the left oscillation disc, as shown
in =`^li\(0.
			Sanding Belt
Efk\1DfjkjXe[`e^Y\ckj_Xm\Xiifnjgi`ek\[fe			Direction
k_\`i`ej`[\jli]XZ\kf`e[`ZXk\k_\[`i\Zk`fef]kiXm$
	=`^li\(/% Tension lever secured under the
\c]fik_\Y\ck%DXkZ_k_\j\Xiifnjn`k_k_\jXe[`e^			bottom catch.
Y\ck[`i\Zk`feXiifnj_fne`e=`^li\(/%
-%When you have the sanding belt evenly positioned						Left
between the oscillation discs on each end of the						Oscillation
upper roller, move the tension lever to the upper						Disc
catch by reversing from Jk\g*.
Efk\1K_\Df[\cN(/(*lj\jXjgi`e^k\ej`fe\ikf
XlkfdXk`ZXccpXggcpk_\Zfii\Zkk\ej`fekfk_\jXe[$
`e^Y\ckn_\ek_\k\ej`fec\m\i`jj\Zli\[fek_\
kfgZXkZ_%
.% Re-tighten the tension lock, then close and secure
the sanding belt access door before starting the					Sanding Belt
sander.
		=`^li\(0% Proper position of the sanding
:fem\pfi=\\[IXk\			belt on the upper roller.
The conveyor feed rate dial (see =`^li\)') adjusts the
feed rate of the conveyor from 5 to 17 feet per minute
(FPM). The correct speed for your operation depends on
the type of stock you are sanding (e.g., hardwood vs. soft-
wood), the depth of cut, and the stage of finish desired.
As a general rule, a slower feed rate will sand the surface
smoother, but runs the risk of burning the wood. A higher
feed rate will remove material faster, but runs the risk of
overloading the motor (refer to 8dg\iX^\CfX[D\k\ion
GX^\)) for more information on sander work load). Use
trial-and-error to determine the correct feed rate for your
operation.
			=`^li\)'% Conveyor feed rate dial.

-21-

FG<I8K@FEJ