Df[\cN(/(0&N(/)' D]^%J`eZ\('&('
:ifjjZlkk`e^
"Crosscutting" means cutting across the grain of a natural wood workpiece. In other
KfdXb\XZifjjZlklj`e^k_\d`k\i^Xl^\#[fk_\j\ jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Ensure that the blade guard/spreader is installed.
*% Move the rip fence aside and position the miter gauge, adjusted to 90°, in a miter slot.
+% Adjust the blade height so the teeth protrude approximately 1/4" above the workpiece.
,% Slide the miter gauge near the blade and adjust the workpiece so the blade will cut on the waste side of the line.
.% Hold the workpiece firmly against the face of the miter gauge (see =`^li\,)) and ease it through the blade until the workpiece is completely past the saw blade.
=`^li\,)%Typical crosscutting operation.
KlieF==k_\jXnXe[Xccfnk_\YcX[\ kf Zfd\ kf X Zfdgc\k\ jkfg Y\]fi\ i\dfm`e^ k_\ Zlk$f]] g`\Z\% =X`cli\ kf ]fccfn k_`j nXie`e^ Zflc[ i\jlck `e j\i`fljg\ijfeXc`ealip%
B\\gk_\YcX[\^lXi[`ejkXcc\[Xe[`e k_\ [fne gfj`k`fe% =X`cli\ kf [f k_`j Zflc[i\jlck`ej\i`fljg\ijfeXc`ealip fi[\Xk_%
FG<I8K@FEJ