Df[\cN(/(0&N(/)' D]^%J`eZ\('&('
D`k\i>Xl^\8[aljkd\ekj
The miter gauge can be adjusted so it is perpendicular to the blade and so it is snug in the
KffcjE\\[\[ | Hkp |
90° Square | 1 |
45° Square | 1 |
Hex Wrench 2.5mm | 1 |
Hex Wrench 2mm | 1 |
Hex Wrench 3mm | 1 |
:_\Zb`e^&J\kk`e^0'Jkfgj |
|
(% DISCONNECT THE SAW FROM POWER! |
|
)% Slide the miter gauge into the
*% Loosen the miter gauge lock knob, pull out the positive stop knob, then pivot the miter gauge body to 90° so the stop knob springs into position.
+% Place the 90° square evenly against the face of the miter gauge and the blade, as shown in =`^li\('0.
—If the square touches the miter body and the body of the blade (not the teeth) evenly at the same time, then it is square to the blade and the 90° stop is set correctly. No further adjustments are necessary.
—If the square does not touch the miter body and blade body evenly at the same time, then proceed to Jk\g,.
,% Loosen the button head cap screws on the positive stop knob block (see =`^li\ (('), adjust the miter body until it is flush with the square, then tighten the screws.
8[aljk`e^D`k\i9XiK`^_ke\jj
The miter bar can be adjusted so it fits more tightly in the miter slot.
To adjust the miter bar tightness, loosen the cap screw on each guide block (see =`^li\(((), adjust the set screws as needed, then tighten the cap screw.
JhlXi\ |
9cX[\ |
D`k\i>Xl^\ |
=`^li\('0% Checking 90° stop on miter
gauge.
Positive
Stop Knob
Button Head
Cap Screws
=`^li\(('% Screws for adjusting miter
gauge body.
Set Screws
Cap Screws |
|
|
| Guide | |
|
| |
| ||
|
| Block |
|
|
|
=`^li\(((% Screws for adjusting miter bar
in miter slot.
J<IM@:<