Woodstock W1820, W1819 manual =\eZ\8aljkd\ekj, JhlXi\Xe?\`k

Df[\cN(/(0&N(/)'D]^%J`eZ\('&('

=\eZ\8[aljkd\ekj

There are four main adjustments for the fence: (1) square,

(2)height, (3) parallelism, and (4) clamping pressure. Keep in mind that these adjustments are interconnected and some trial-and-error may be needed to achieve satisfactory results.

KffcjE\\[\[	Hkp
Hex Wrench 6mm	1
Square	1
Felt-Tipped Marker	1

JhlXi\Xe[?\`^_k

The fence face must be square to the table in order to produce square cuts. The fence should be adjusted so it does not drag across the table surface.

KfZ_\Zb&X[aljkk_\]\eZ\_\`^_kXe[jhlXi\e\jjkfk_\ kXYc\#[fk_\j\jk\gj1

(% DISCONNECT THE SAW FROM POWER!

)% Place a square on the table against the face of the fence (see =`^li\('*) to check if the fence is square to the table.

— If the fence is square to table, go to Jk\g+.

0'—JhlXi\

=\eZ\

KXYc\

=`^li\('*% Checking if fence is square to

table.

J<IM@:<

— If the fence is not square to table, go to Jk\g*.

*% Adjust the set screws (see =`^li\('+) on top of the fence bracket to ensure the fence face is 90° to the table, then tighten the knurled lock nuts.

+% Look at the gap between the fence and table top.

—If the gap is approximately 1⁄16" and even from the front of the table to the back, then no additional adjustments are necessary.

—If the gap is uneven, if the fence height is more than 1⁄8", or if the fence touches the table, then continue with Jk\g,.

,% Adjust the fence height with the rear rail foot until the gap between the table and the fence is approximately 1⁄16" and even from the front of the table to the back. Efk\1 @]k_\]ifek\e[f]k_\ ]\eZ\e\\[jkfY\X[aljk\[lgfi[fne#lj\k_\ j\kjZi\nj]ifd=`^li\('+2kliek_\d`e\m\e `eZi\d\ekjXe[i\Z_\Zbk_\jhlXi\e\jjX]k\inXi[j%

J\kJZi\nj
CfZbElk
=\eZ\	I\XiIX`c
	=ffk
9iXZb\k

=`^li\('+% Fence components used to adjust fence height and squareness to table.

-70-