Sears 113.197411, 113.197611, 113.197511 owner manual Alignment and Adjustment

Alignment and Adjustment

2.Place square so long edge rests on table and short edge rests against blade surface, not on a tooth.

3.There should be no gap between blade and square. Note: Not all blades are per-

fectly flat. Check different points along blade surface by making quarter turns and looking for gap each time. Consider overall fit of blade. If there is no gap, no adjust- ment is needed.

Correct

I

t

Wrongwrong

4.If there is a gap, adjust motor:

i)unlock bevel lock

ii)loosen four socket head screws behind blade carriage

iii)move motor until blade rests flush against square

iv)lock bevel lock.

5.Re-check alignment and adjust as

needed.

6. Tighten four socket head screws be-@ hind blade carriage.

41