Sears 113.197611, 113.197511 Alignment and Adjustment, Install Drawers Only Drawer Model

Assembly

4. Attach slide arms to slide arm sup- ports: use one 1W' long screw per slide arm; put fiat washer on screw; insert screw through slide arm; on other end of screw put another flat washer; put screw through slide arm support; on end of

screw put lock washer, then hex nut and

wrench tighten.

!

5. Attach slide arms to lock handle chan- nels: use one _" long screw per slide arm; insert screw through slide arm; on end of screw put flat washer; put screw through lock handle channel; on end of screw put square lock nut and tighten.

Install Drawers (Only Drawer Model)

1.Slide each drawer into place and push all the way in.

2.Pull each drawer out as far it will go. They should not come all the way out. If

any do, use screwdriver to bend out stop tabs on slide brackets and re-test drawer.

To Remove Drawers (Only Drawer

Model)

1.Llse screwdriver to push in one stop tab on right slide bracket and at same time pull drawer out slightly.

2.Repeat with left slide bracket and pull drawer all way out.

Alignment and Adjustment

Go to Alignment and Adjustment Section

and follow all instructions. You cannot use the saw until it is aligned and ad- justed. It may be helpful to read the Con- trols Section before proceeding with alignment and adjustment.

Reinaining parts will be installed in Digi- tal Display Section.

33