Sears 113.197411, 113.197611, 113.197511 owner manual Align Encoders, Miter Encoder

Digital Display

Align Encoders

Miter Encoder

1.Turn display on.

2.Lock radial arm at 0 ° miter.

3.Push MITER button.

4.Push REF SET button. Display will read:

5.Unlock miter lock, move radial arm to

right until it snaps into pre-set indexed position and lock miter lock. Display should read:

6.Unlock miter lock, move radial arm to left until it snaps into pre-set indexed

position, and lock miter lock. Display should read:

7.If display reads as it should, miter en-

coder is aligned correctly---no adjustment is needed.

8.If display does not read as it should:

i)unscrew two screws from back cover of radial arm, and remove cover

ii)unlock miter lock, move arm to right until it snaps into pre-set indexed posi- tion, and lock miter lock

iii)loosen miter encoder mounting

screws inside rear of radial arm to allow encoder to slide side to side

iv)slide or slightly tap encoder until display reads 45 °

v)tighten miter encoder mounting screws.

9.Repeat steps to align miter encoder. When display reads as it should, re-install back cover.

I MIT. _"1mJ

I _I.U

J. U I

Screws

Encoder

5O