Sears 113.197611 Set Zero Reference Points For Bevel, Miter, and Elevation, Bevel Encoder

Bevel Encoder

1.Turn display on.

2.Lock radial arm at 0 ° miter. Lock motor at 0 ° bevel.

3.Push BEVEL button.

4.Push REF SET button. Display will read:

5.Support motor, unlock bevel lock,

move motor counterclockwise until it

snaps into pre-set indexed position and lock bevel lock. Display should read:

6.Support motor, unlock bevel lock,

move motor counterclockwise until it

snaps into next pre-set indexed position

(blade horizontal) and lock bevel lock. Display should read:

7. If display reads as it should, bevel en-

coder is aligned correctly--no adjustment is needed.

8.If display does not read as it should:

i)unlock bevel lock, move motor clock- wise until it snaps into pre-set indexed position, and lock bevel lock

ii)loosen bevel encoder screws on

backside of blade carriage to allow encoder to slide side to side

iii)slide or slightly tap encoder until display reads 45 °

iv)tighten bevel encoder screws.

9.Repeat steps to align bevel encoder.

Set Zero Reference Points For

Bevel, Miter, and Elevation

1. Set blade in straight crosscut position

(0 ° miter) (0 ° bevel). Lower blade until it just touches table. Note: This i_ the usual blade position for settb N these zero refer- ence points.

Digital Display

V!

BEv •U

£1.U [

BEVq'U.U -"I-'

Bevel

Encoder

Screws

Bevel

51