3.12Bucky Movement Path Safety Switch
Move the Bucky to the foot end to the mechanical stop, move the system carriage into the exposure position. Adjust the S12 switch (Fig. 66/Pos. 1) so that it positively switches.
3.13 I.I. Carriage Movement Path Safety Switch
Remove the cover panel (Fig. 65/Pos. 1). Move the system carriage to the head end until there is 3 mm distance and adjust the switch strike plate (Fig. 67/ Pos. 1) so that it just actuates the S6 switch. Move the system carriage to the foot end until there is 3 mm distance and adjust the switch strike plate (Fig. 67/Pos. 2) so that it just actuates the S7 switch.
Fig.67 |
Fig.68 |
3.14 Table Up Movement Path Switch Strike Plate
Raise the table to max.
When the software limit is set, the top switch strike plate (Fig. 68 / Pos. 1) can be adjusted so that the limit switch (Pos. 3) actuates approx. 2 - 5 mm behind the maximum height.
3.15 Table Down Movement Path Switch Strike Plate
Lower the table to the min.
When the software limit is set, the bottom switch strike plate (Fig. 68/ Pos. 2) can be adjusted so that the limit switch actuates approx. 2 - 5 mm behind the minimum height.
06/00 | - 55 of 90 - | 0116 7201 |
Rev. 00 © 2000 Hans Pausch Röntgengerätebau Graf