Lift and tilt drive:
-Move through the entire lift and tilt range.
-Check for soft start and movement out of positions.
-Check automatic stop in the horizontal position.
-Check automatic stop in the vertical position (88°).
-Check automatic stop in the Trendelenburg position
-Check stop with manual actuation of the limit switches.
-Clean the guide rails and the counterweight guides.
-Check for play in the bearings. If necessary, readjust them.
Tabletop drive:
-Move through the entire longitudinal and transverse movement range.
-Check for soft start and movement out of positions.
-Check automatic stop in
-Check automatic stop in
-Check automatic stop in the left limit position.
-Check automatic stop in the right limit position.
-Check automatic stop in the center position.
-Lift up the tabletop and clean the space in between.
Tube unit carriage drive:
-Move through the entire movement range.
-Check soft start and movement out of positions.
-Check automatic stop in
-Check automatic stop in
-Clean guide rails.
-Check for play in the bearings. If necessary, readjust them.
Bucky carriage drive:
Preparations:
Switch the unit to the service mode, the green LED on the controller goes on green continuously. Press the Store and Reset buttons at the same time, the three memory LED’s on the controller will blink green and the LED on the controller will blink very quickly. See
3.24
The cassette can now be moved forward and backward slowly by pressing the Recall and Reset buttons.
-Move through the entire movement range.
-Check soft start and movement out of positions.
-Check automatic stop in
-Check automatic stop in
-Clean the guide rails.
-Check for play in the bearings. If necessary, readjust.
I.I. carriage drive:
-Initiate movement through entire movement range.
-Check soft start and movement out of movements.
-Check automatic stop in
0116 7201 | 06/00 |
Rev. 00 © 2000 Hans Pausch Röntgengerätebau Graf