For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1029 |
Test Run
If this machine is new and being put into service, or if it has been in storage for a period of time, the machine and its safety features must be tested to ensure correct operation. Complete all preparation steps and lubrication as outlined in Basic Lubrication on Page 33. If you discover a problem with the operation of the machine or its safety components, do not operate it further until you have resolved the problem.
Refer to Troubleshooting on Page 36 for solutions to common problems that may occur with surface grinders. If you need additional help, contact our Technical Support at (360) 734- 1540.
To test run your machine:
1.Read and follow the safety instructions at the beginning of the manual, take the required safety precautions, and make sure the machine is set up and adjusted properly.
3.Clear away all tools and objects used during assembly and preparation.
4.Flush and fill the oil reservoir as instructed in Basic Lubrication on Page 32 and verify that the oil pump is operating.
5.Connect the machine to the power source.
6.Push the OFF button in, then twist it clockwise so it pops out. When the OFF button pops out, the switch is reset and ready for operation (Figure 15).
|
|
|
| wis | t C |
|
|
|
|
| t T |
|
| ||
|
| e |
| l |
| ||
|
| s |
|
|
| o | |
|
| e |
|
|
|
| c |
|
|
|
|
|
| k | |
| o | R |
|
|
|
| w |
|
|
|
|
|
| ||
|
|
|
|
|
| e | |
T |
|
|
|
|
|
| i |
|
|
|
|
|
| z | |
|
|
|
|
|
|
| |
STOP Button
Figure 15. Machine stop button.
7.Verify that the machine is operating correctly by pushing the ON button.
—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.
—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always stop the machine and disconnect it from power before investigating or correcting potential problems.
8.Press the OFF button to stop the machine.
9.WITHOUT resetting the switch, press the ON button. The machine should not start.
—If the machine does not start, the OFF button safety feature is working correctly.
—If the machine does start (with the stop button pushed in), immediately disconnect power to the machine. The OFF button safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations.
Call Tech Support for help.