Model SB1029 | P R E P A R A T I O N | For Machines Mfg. Since 8/09 |
Power Connection
Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use a qualified electrician to ensure a safe power connection.
Initial Lubrication
Your machine was lubricated at the factory, but we strongly recommend that you inspect all lubrication points yourself and provide additional lubrication if necessary. Refer to Basic Lubrication on Page 33 for specific details and to fill the oil reservoir.
THIS
MACHINE
REQUIRES OIL!
Once your machine is set up and assembled as previously described in this manual, it is ready to be connected to the power source.
—If you plan to use the machine at 220V, you will have to install the recommended plug and plug it into a receptacle on a 220V circuit that meets the requirements listed on Page 10.
—If you plan to use the machine at 440V, you will have to convert the machine for 440V and hardwire it to a 440V circuit that meets the requirements listed on Page 10. Refer to Electrical, beginning on Page 39.
OPERATING
WITHOUT OIL WILL
CAUSE DAMAGE
AND VOID
WARRANTY!
Inspections & Adjustments
The following list of adjustments were performed at the factory before your machine was shipped:
ssTable Backlash Adjustment on Page 35
ssRing Test on Page 23
ssWheel Dressing on Page 28
ssWheel Balancing on Page 29
ss#HANGING /IL !DJUSTING /IL &LOWDon
Page 34