DeWalt DWE575SB instruction manual Bevel Detent Fig, Bevel Angle Adjustment Fig

FIG. 8	adjustment lever (F). The angle							FIG. 9	LOOSEN
	quadrant	allows		for	coarse					F
	adjustment. To achieve					better
	accuracy in cutting, use the fine
	adjustment		markings		located
	on the pivot bracket (U). The full
	range of bevel adjustment is 0
	to 57 degrees. The pivot
	bracket	is	graduated				in
3. For the most efficient cutting action using a carbide tipped saw	increments of 1 degree.									TIGHTEN
	1. To set		the	saw		for	a
blade, set the depth adjustment so that about one half of a tooth
projects below the surface of the wood to be cut.	bevel		cut,	raise			the
4. A method of checking for the correct cutting depth is shown in	bevel	adjustment				lever		U T	G	V
Figure 8. Lay a piece of the material you plan to cut along the side	(F) to loosen the bevel
of the blade, as shown in the figure, and observe how much tooth	adjustment.
projects beyond the material.	2. Tilt the foot plate to the desired angle by aligning the pointer (T)
ADJUSTING DEPTH ADJUSTMENT LEVER (FIG. 7)	with the desired angle mark on the pivot bracket (U).
	3. Retighten the bevel adjustment by lowering the lever.
It may be desirable to adjust the depth adjustment lever (P). It may
	Bevel Detent (Fig. 9)
loosen in time and hit the foot plate before tightening.
To tighten the lever, follow the steps below.	WARNING: To reduce the risk of injury, turn unit off and

1.Hold depth adjustment lever (P) and loosen the locknut (S). disconnect it from power source before installing and removing

2. Adjust the depth adjustment lever by rotating it in the desired	accessories, before adjusting or when making repairs. An
direction about 1/8 of a revolution.	accidental start-up can cause injury.
3. Retighten nut.	The DWE575 and DWE575SB are equipped with a bevel detent
Bevel Angle Adjustment (Fig. 9)	feature. As you tilt the foot plate you will hear a click and feel the foot
	plate stop at both 22.5 and 45 degrees. If either of these is the desired
WARNING: To reduce the risk of injury, turn unit off and	angle, retighten the lever (F) by lowering it. If you desire another angle,
disconnect it from power source before installing and removing	continue tilting the foot plate until the coarse bevel pointer (V) or the
accessories, before adjusting or when making repairs. An	fine pointer (T) aligns with the desired mark.
accidental start-up can cause injury.
On the front of the saw is a bevel angle adjustment mechanism (G)
which consists of an angle quadrant with a pointer (T) and a bevel

9

English