INSTALLING THE DRIVE BELT
Disconnect the machine from the power source!
1.Lift the motor to remove the foam packing block.
2.While lifting the motor (A) Fig. 5, place a 10" - 12" long piece of 2x4 under the motor (B) Fig. 8 to prop up the motor.
3.Place the grooved belt (C) Fig. 6 on the grooved pulley located behind the motor (shown in Fig. 7) and the pulley directly above, located on the opposite end of the blade arbor.
Ensure that the grooves of the belt completely make contact with the grooves in these pulleys.
.
4.Carefully lift the motor and remove the block of wood. The weight of the motor will provide the correct tension on the belt.
5.The belt (D) Fig. 8 is shown installed correctly as seen through the open door in the side of the saw.
A
B
Fig. 5
C
Fig. 6
Fig. 7
D
Fig. 8
9