ATTACHING A SAW BLADE
Disconnect the machine from the power source!
1.Raise the saw blade arbor to its maximum height. Attach the saw blade (C) Fig. 25 to the saw arbor with the teeth of the blade pointing down toward the front of the table (Fig. 25). Attach the flange (D) and arbor nut
(E)to the saw arbor. Tighten the arbor nut (E) by hand with the saw blade against the inner blade flange.
2.Place the open end wrench (F) Fig. 25 on the flats of the saw arbor and tighten the arbor nut (E) with the other wrench (G). Turn the arbor nut clockwise.
G
F
D
C
E
ALIGNING THE SPLITTER WITH THE BLADE
Disconnect the machine from the power source!
Use a straight edge to check the alignment of the saw blade (B) with the rear of the splitter (G) in Figs. 26 and
27.If alignment is necessary, loosen the screws (A) Fig. 28 that hold the splitter bracket to the rear trunnion. Align the splitter (G) Fig. 26 with the saw blade and tighten two bolts
(A) Fig. 28.
B
G
Fig. 27
INSTALLING TABLE INSERT
Disconnect the machine from the power source!
Lower the saw blade and install the table insert (P) Fig. 29 in the saw table.
IMPORTANT: When installing the table insert, hold the blade guard (L). After insertion, the insert will automatically release the holding action of the splitter and lower the blade guard.
Secure the insert with the M5 x 20mm screw in the hole
(M).
Fig. 25
G
B
Fig. 26
A
Fig. 28
L
M
P
Fig. 29
13