Black & Decker FS200SD instruction manual Attaching Blade Height Adjusting Handwheel

ATTACHING BLADE HEIGHT ADJUSTING HANDWHEEL

1.Insert an M6x1x55mm pan head screw (D) Fig. 14 through the handle (E). Attach the handle (E) to the handwheel

(A) by threading the screw (D) clockwise into the handwheel.

2.Attach the handwheel (A) Fig. 15 to the shaft (B). Align the flat on the inside of the handwheel to the flat on the shaft.

A

E

D

Fig. 14

B

A

Fig. 15

A

3.Fasten the handwheel (A) Fig. 16 to the shaft using an M6x1x12mm flat head screw (C)

C

Fig. 16

ATTACHING BLADE GUARD AND SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM POWER SOURCE.

PROPERLY ALIGN THE BLADE GUARD

AND SPLITTER ASSEMBLY WITH THE

SAW BLADE TO PREVENT KICKBACK.

1.Position the blade 90 degrees to the table and lock in place.

2.Fasten the splitter support bracket (A) Fig. 17 to the splitter bracket (B) using two 1/4-20x1/2" hex head screws (C) and two 1/4" external tooth lockwashers

(D).

NOTE: Loosely tighten the screws for further adjustment.

A B

C

D

Fig. 17

12