Black & Decker FS200SD instruction manual On the screw L Fig

3.Locate the 1/4-20x2" hex head screw (G) Fig. 18. Place the 1/4" internal tooth lockwasher (O) M6.4 flat washer (P) and the 1/4" external tooth lockwasher (R) on the screw (G).

4.Position the recessed end (E) Fig. 19 of the splitter bracket (B) against the end of the pivot rod (F), and fasten using the assembly in STEP 3. NOTE: Do not completely tighten screw (G) at this time. Assembly shown in Fig. 20.

NOTE: Loosely tighten the hardware for further adjustment.

5.Position the splitter (H) Fig. 21 against the splitter support bracket, making certain the two protrusions (K) on the splitter support bracket are inside the slot of splitter (H).

R

P

O

G

Fig. 18

G

Fig. 20

6.Attach the splitter (H) Fig. 22 to the splitter support bracket (B). Place a 1/4" external tooth lockwasher and an M6.4 flat washer on an M6x1x20mm hex head screw (L).

7.Insert the screw (L) Fig. 22 through the splitter support bracket (C) and the splitter (H). Place an M6.4 flat washer and a 1/4" external tooth lock washer on the screw (L). Thread an M6x1 wing nut

(M) Fig. 23 on the screw (L) Fig. 23.

F

E

B

Fig. 19

H

K

Fig. 21

C

L

H

B

Fig. 22

13