Craftsman 286.17589 operating instructions

A'I-rACHINGREPLACEMENT BLADES TO THE SAW (See Figs. 17 - 20)

and no other types or sizes of blades shouldever be used. Other types and sizes

of.blades will not operate safely in this saw and could result in serious personal ,/_ WARNING: ThisTwin Cutter saw uses specially designed5-in. blades injury.

See the accessories section of this manual for the proper replacement blades that are needed for this saw.

1, Unplug the saw,

,/causingWARNING:possibleseriousFailuretopersonalinjury,unplugthe saw could result in accidentalstarting

2, Lay the saw clown with the blade arbor pointingupward.

3, Place blade"A" onto the bladeflange with the "A" clearlyvisible (see Fig. 17).

4.Align the holes on the blade with the pinson the flange and securely fitthe blade on the flange (see Fig, 18),

5.Take the arbor adapter "1" and push it down onto the flange with the "1" clearly visible.Make sure that the adapter is properly seated over the flat sides of the flange.(see Fig, 18),

6, Place blade "B" onto the adapter with the "B" easily visible,then thread lock nut onto shaft. DO NOT tighten, (see Fig. 19).

7.Turn the blades so that the holes in both blades are lined up.

Fig. 18

Flange

Fig. 19

I

I

18