Product Overview
Product Overview
HTX 2030 with Base Coat Pump (257369)
1.Flow 3 (fully clockwise) - allows the pump to run continuously:
ti13756a
ti13632a
The HTX 2030 Sprayer comes equipped with a Base Coat Pump 24B321. Only
•Smooth to heavily aggregated textures with silica sand, perlite, vermiculite and polystyrene
•Smooth, medium, coarse and extra coarse textures
•Most materials with aggregates up to 2.5 mm (.100 in.) in longest dimension
When Base Coat Pump is Installed
Pump will only run when ON/OFF switch is in ON posi- tion and:
•Pump control is rotated clockwise away from OFF position, and either of the following switches are also switched ON:
Prime Switch on pressure control box and/or Applicator Switch near end of material hose
The pressure control will limit the sprayer to 1,000 psi (69 bar), stopping the pump whenever pressure limit is reached.
The pump control on the pressure control adjusts the flow rate depending on engine speed and the setting of the pump control.
2.Flow 2 (near middle of the rotation) reduces flow slightly by briefly interrupting pump:
ti13757a
3.Flow 1 (near counterclockwise end of pump control) reduces flow more by interrupting pump longer:
ti13758a
4.OFF (fully counterclockwise) - stops pump com- pletely:
ti13755a
NOTE: Adjusting engine speed is an effective way to control flow rate of sprayer. Different spray tip or nozzle sizes can also be tried.
313483A | 7 |