Graco Inc 313483A Setup / 设置, Material and Sprayer Preparation, 涂料及喷涂机的准备

Operation / 操作

Setup / 设置

	ti13899a	ti13639a
ti4118a

English

1.	Fill mixing pail with	2. Connect material hose to pump out-	Material and Sprayer Preparation
	pre-mixed texture mate-	let.	NOTE: A dry material hose can extract
	rial.
			water from the material and lead to a
	Add approximately 10%		plugged hose. If the inside of the hose
			is dry, pump water through it before
	water to texture mix or
			pumping texture material.
	per material manufac-
	turer instructions. Mix		Cementicious and other curing materi-
	thoroughly.
			als can harden within the drain valve
			while spraying. At least once per hour
			stop spraying and open the drain valve
			to flush out the older material.
中文
1.	将预先混合好的纹理涂料	2. 将料管连接至泵出口。	涂料及喷涂机的准备
	倒入混合桶内。		注释：干的料管会从涂料中吸水并导致
	向纹理涂料混合液中加		软管堵塞。如果软管内壁干燥，在泵送
			纹理涂料之前要先用其抽水。
	入大约 10% 的水，或根
	据涂料生产厂家的说明		水泥基或其它能固化的涂料会在喷涂期
	添加。彻底混合。
			间在泄压阀内固化。应至少每小时停止
			喷涂一次，并打开泄压阀以冲出较旧的
			涂料。

NOTICE

DO NOT USE MATERIALS THAT CURE RAPIDLY! Materials with a fast curing time could plug the pump, hose, gun, or applicator.

注意

不要使用快速固化的涂料！快速固化 的涂料可能会堵塞泵、软管、喷枪或 喷涂器。

313483A 17