Troubleshooting
Troubleshooting
Problem | Cause | Solution |
|
|
|
|
|
|
E=XX is displayed | Fault condition exists | Determine fault correction from table, page 35. |
Engine will not start | Engine switch is OFF | Turn engine switch ON |
|
|
|
| Engine is out of gasoline | Refill gas tank. Honda Engines Owner's Man- |
|
| ual. |
|
|
|
| Engine oil level is low | Try to start engine. Replenish oil, if necessary. |
|
| Honda Engines Owner's Manual. |
|
|
|
| Spark plug is disconnected or damaged | Connect spark plug cable or replace spark plug |
|
|
|
| Cold engine | Use choke |
|
|
|
| Fuel shutoff lever is OFF | Move lever to ON position |
|
|
|
| Oil is seeping into combustion chamber | Remove spark plug. Pull starter 3 to 4 times. |
|
| Clean or replace spark plug. Start engine. |
|
| Keep sprayer upright to avoid oil seepage |
|
|
|
Engine operates, but displacement | Error code displayed | Reference Pressure Control repair, page 61. |
pump does not operate |
|
|
Applicator switch is OFF | Turn applicator switch ON | |
|
|
|
| Pump setting too low | Turn pressure adjusting knob clockwise to |
|
| increase pressure. |
|
|
|
| Tip or tip filter is clogged | Clean tip or tip filter, see manual |
|
| 313537/313603. |
|
|
|
| Displacement pump piston rod is stuck | Repair pump, see manual 310894 or page 70. |
| due to dried paint or texture |
|
|
|
|
| Connecting rod is worn or damaged | Replace connecting rod. Page 43. |
|
|
|
| Drive housing is worn or damaged | Replace drive housing. Page 46. |
|
|
|
| Electrical power is not energizing clutch | Check wiring connections. Page 84. |
| field | Reference Digital Display Messages. |
|
| |
|
| Page 35. |
|
| Reference wiring diagram. Page 84. |
|
| With applicator switch ON and pressure turned |
|
| to MAXIMUM, use a test light to check for |
|
| power between clutch test points on control |
|
| board. |
|
| Remove clutch wires from control board and |
|
| measure resistance across clutch coil. At 70° F |
|
| (21° C), the resistance must be between 1.2 |
|
| +0.2Ω; if not, replace pinion housing. |
|
| Have pressure control checked by authorized |
|
| Graco dealer |
|
|
|
| Clutch is worn, damaged, or incorrectly | Adjust or replace clutch. Page 57. |
| positioned |
|
|
|
|
| Pinion assembly is worn or damaged | Repair or replace pinion assembly. Page 49. |
|
|
|
| Base Coat Pump: Applicator switch on | See page 70. |
| material hose and/or Prime Switch on |
|
| Pressure Control are damaged. |
|
|
|
|
| Top Coat Pump: Pump is not correctly | Rotate pump to align transducer port toward |
| aligned to pump sensor or sensor is | back of sprayer. Replace damaged pump sen- |
| damaged. | sor. |
|
|
|
313483A | 39 |