Bosch Power Tools 400 Series XPR manual General Specifications, Motor Specifications

SPECIFICATIONS

General Specifications

Voltage Rating . . . . . . . . . .120 V, 50-60 Hz Amperage Rating . . . . . . . . . . . . . . . . .2.0 A No Load Speed . . . . . . . . . .No 35,000/min Collet Capacity . . . .1/32", 1/16", 3/32", 1/8"

Motor Specifications

This Rotary Tool utilizes a variable high- speed RPM motor. It is wired for operation on 110-120 volts, 50-60 Hz. alternating current. Before connecting the motor cord to wall out- let, make certain the power switch is in the OFF position and be sure the electric current is of the same characteristics as stamped on the Rotary Tool nameplate.

Connection To A Power Source

! DANGER To avoid electric shock, do not touch the metal prongs on the plug when installing or

removing the plug to or from the outlet. ! DANGER If power cord is worn, cut

or damaged in any way, have it replaced immediately to avoid shock or fire hazard.

Extension Cords

If an extension cord is necessary, a cord with adequate size conductors that is capable of carrying the current necessary for your tool must be used. This will pre- vent excessive voltage drop, loss of power or overheating.RECOMMENDED SIZES

OF EXTENSION CORDS

120 VOLT ALTERNATING CURRENT TOOLS

NOTE: The smaller the gauge number, the heavier the cord.

Tool’s	Cord Size in A.W.G.				Wire Sizes in mm2
Ampere	Cord Length in Feet				Cord Length in Meters
Rating	25	50	100	150	15	30	60	120
2-6	18	16	16	14	.75	.75	1.5	2.5
6-8	18	16	14	12	.75	1.0	2.5	4.0
8-10	18	16	14	12	.75	1.0	2.5	4.0
10-12	16	16	14	12	1.0	2.5	4.0	—
12-16	14	12	—	—	—	—	—	—

6