Item Control/Feature | Icon Description |
•Steady green: Battery is ready
2 | Battery fault indicator | • Off: No faults |
•Blinking amber: Correctable fault detected
•Steady amber: Uncorrectable fault detected; replace battery
3 | MGMT port | — | 10 Mbps, 100 Mbps, or 1 Gbps Ethernet/iSCSI port used for | |
|
|
| storage system management and access to the BMC | |
|
|
|
| NOTE: To use the MGMT port as an iSCSI port for |
|
|
|
| replication to another Storage Center, a Flex Port license |
|
|
|
| and replication license are required. To use the MGMT port |
|
|
|
| as a |
|
|
|
| license is required. |
4 | REPL port | — | 10 Mbps, 100 Mbps, or 1 Gbps Ethernet/iSCSI port used for | |
|
|
| replication to another Storage Center (requires a replication | |
|
|
| license) | |
|
|
|
| NOTE: To use the RELP port as a |
|
|
|
| host servers, a Flex Port license is required. |
5 | SAS activity indicators | — | • | Off: Port is off |
|
|
| • Steady green: Port is on, but without activity | |
|
|
| • Blinking green: Port is on and there is activity | |
6 | Storage controller |
| On: Storage controller completed POST | |
| module status |
|
|
|
7 | Recessed power off |
| Powers down the storage controller if held for more than five | |
| button |
| seconds | |
8 | Storage controller |
| • | Off: No faults |
| module fault |
| • Steady amber: Firmware has detected an error |
• Blinking amber:Storage controller is performing POST
9Recessed reset button
10Identification LED
11USB port
12Diagnostic LEDs (8)
13Serial port (3.5 mm mini jack)
Reboots the storage controller forcing it to restart at the POST process
• Off: Identification disabled
•Blinking blue (for 15 sec.): Identification is enabled
•Blinking blue (continuously): Storage controller shut down to the Advanced Configuration and Power Interface (ACPI) S5 state
Not for customer use on SCv2000/SCv2020 Storage Systems.
—• Green LEDs
• Green LEDs
Not for customer use.
About the SCv2000/SCv2020 Storage System | 11 |