Carrier 19XRV specifications A19-1834, Wire Lugs

A19-1834

Fig. 7 — Enclosure Dimensions - Frames 6 and 7

START-UP

DANGER

Internal components and circuit boards of the drive are live when the drive is connected to incoming power. Coming into contact with this voltage is extremely dangerous and will result in severe personal injury or death.

The motor terminals U, V, W and the DC-link/brake resis- tor terminals B+/R+, R- are live when the drive is con- nected to incoming power, even if the motor is not running.

Do not make any connections when the drive is connected to the incoming power.

After having disconnected the drive, wait until the indica- tors on the keypad go out (if no keypad is attached see the indicator through the keypad base). Wait 5 more minutes before doing any work on drive connections. Do not even open the cover before this time has expired..

Before connecting the drive to the incoming power, make sure that the switchgear enclosure door is closed.

WARNING

The control I/O-terminals are isolated from the mains potential. However, the relay outputs and other I/O termi- nals may have a dangerous control voltage present even when the drive is disconnected from incoming power. Coming into contact with this voltage could result in severe personal injury.

CAUTION

If other than refrigerant cooling is used, before connecting the drive to the incoming power, make sure that the coolant is circulating and has no leaks.

CAUTION

When working with the Drive Explorer, never use the Rotate function as the motor will immediately start and severe compressor damage could result.

Alternate Wire Lugs — In the case where the incoming power wire size does not fit the standard lug, alternate lugs may be used. See Table 1. Note that lugs rated for a higher current than the circuit breaker may be used.

Table 1 — Wire Lugs

Verify Installation — Record the following job information:

1.Job Name

2.Job Number

3.City

4.State

5.Zip Code

Record the following nameplate information:

1.From the Allen-Bradley nameplate (Fig. 1) located inside the VFD enclosure:

a.Allen-Bradley ID or CAT NO.

b.Allen-Bradley Serial Number

c.Carrier Part Number

2.From the machine nameplete (Fig. 8) located inside the VFD enclosure:

a.Chiller Serial Number

b.Chiller Model

c.Motor rated load amps

d.Motor nameplate rpm

e.Motor nameplate kW

f.Motor nameplate voltage

g.IPWM (pulse width modulation) frequency

h.Voltage

3.From the drive module label (Fig. 9) located on the drive module:

a.Model or Cat. Number

b.Serial Number

4.From the ICVC control panel screen:

a.Carrier Part Number and Revision

b.ICVC Software Number

Rockwell PowerFlex 750 drive start-up must be registered on the Rockwell website. Rockwell Registration site URL: http://www.automation.rockwell.com/warp/default.asp

5