Welding Guidelines (Continued)
PUSH VS PULL TECHNIQUE
The type and thickness of the work piece dictates which way to point the gun nozzle. For thin materials (18 gauge and up), the nozzle should point out in front of the weld puddle and push the puddle across the workpiece. For thicker steel, the nozzle should point into the puddle to increase weld penetration. This is called backhand or pull technique (See Figure 11).
Figure 10 - Multiple Weld Passes
Model WF2010
PULL
PUSH
Figure 11
Normal Heat, Wire Speed, Travel Speed
Heat Too Low
Heat Too High
Figure 12 - Weld Appearance
Base Metal
Travel Speed Too Fast
Travel Speed Too Slow
Wire Speed Too Slow
Wire Speed Too Fast
Supply Cable Replacement
1.Unplug welder.
2.Remove the right side panel.
3.Disconnect the black and white power cord wires connected to the ON/OFF switch.
4.Disconnect the green power cord wire connected to the frame.
5.Loosen the cord strain relief screw and pull cord through front panel.
6.Install new cord in reverse order.
www.chpower.com
7