Delta 50-786 instruction manual Attaching the TOP Filter, Bag, Attaching the Dust, Collection BAG

ATTACHING THE TOP FILTER

BAG (fig. 27, 28)

1.Place a large 5/16" flatwasher (BB) on a 5/16" x 1"

(25.4 mm) hex head bolt (CC).

2.Position the bracket (DD) on the dust collector.

3.Insert bolt through the hole in the bracket, then thread it into the hole in the dust collector. Tighten securely with a 12 mm wrench.

4.Insert the rod into the pocket (EE) on the filter bag.

6.Insert the rod in the hole in the bracket (FF) (inset).

7.Work the open end of the filter bag into the top groove of the dust collector drum until it is secure and sealed. Bend and fold, as necessary, the internal bag retainer ring to fit it into place.

ATTACHING THE DUST

COLLECTION BAG (fig. 29, 30)

1.Bring the clear plastic dust collection bag up through the middle of the cloth-covered bag retainer ring (GG). Fold about 6" (152.4 mm) of the bag back down around the retainer ring.

2.Place the bag up into in the large hole (HH) in the motor/blower assembly. Fit the retainer ring (GG) into the bottom groove (II). Bend and fold the ring to fit it into place.

3.Tug slightly on the bag to eliminate any slack and to make sure that the bag is secure and will not detach during collection.

BB

CC

DD

FIG. 27

EE

FF

FF

GG

GG

FIG. 28

FIG. 29

HH

II

FIG. 30

12