DEFAULT PARAMETERS
Loading Default Operating Parameters
The control parameters can be loaded with predeter- mined default values. These are the settings loaded into the instrument prior to shipment from the factory. To load the default values proceed as follows:
a)Press and hold the 
key and press the 
key; the displays will show:
b) Press either the 
or 
key; the display will show:
c) Press the "FUNC" key; the display will show:
This indicates that the loading procedure has been initiated. After about 3 seconds the loading procedure is complete and the instrument reverts to the “Normal Display Mode.” The following is a list of the default operating parameters loaded during the procedure:
Default Operating Parameters List
Parameter | Default Value |
Alarm Acknowledge | OFF |
Software Key | Unlock |
Setpoint Threshold | Low range value (if low limit) |
| High range value (if high or high/ |
| low limit) |
Setpoint1 Threshold | Low range value |
Setpoint Threshold |
|
Hysteresis | 0.1% |
Alarm Threshold | Low range (if process alarm) |
| 100 (if deviation or band alarm) |
Alarm Hysteresis | 0.1% |
Loading Default Configuration Parameters
The configuration parameters can be loaded with prede- termined default values. These are the settings loaded into the instrument prior to shipment from the factory. To load the default values proceed as follows:
a)Internal switch V101 must be open.
b)The upper display will show:
c)Press the 
key; the lower display will show the firmware version.
2 4
24 | 9/17/02, 2:42 PM |