English
10.KEEP CHILDREN AWAY.
Do not let visitors contact tool or extension cord.
All visitors should be kept safely away from work area.
11.DON’T FORCE TOOL.
It will do the job better and safer at the rate for which it was intended.
12.USE RIGHT TOOL.
Don’t force small tool or attachment to do the job of a
Don’t use tool for purpose not intended
13.DRESS PROPERLY.
Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and
14.USE FACE, DUST MASK OR RESPIRATOR IF OPERATION IS DUSTY.
All persons in the area where power tools are being operated should also wear face, dust mask or respirator.
15.DON’T ABUSE CORD.
Never carry tool by cord or yank it to disconnect from receptacle. Keep cord from heat, oil and sharp edges.
16.SECURE WORK.
Use clamps or a vise to hold work. It’s safer than using your hand and it frees both hands to operate tool.
17.DON’T OVERREACH.
Keep proper footing and balance at all times.
18.MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and safer performance. Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and if damaged, have repaired by an authorized service center. Inspect extension cords periodically and replace if damaged.
Keep handles dry, clean, and free from oil and grease.
19.REMOVE ADJUSTING KEYS AND WRENCHES.
Keys and adjusting wrenches remove from tool before turning it on.
20.OUTDOOR USE EXTENSION CORD.
When tool is used outdoors, use only extension cord intended for use outdoors and so marked.
21.STAY ALERT.
Watch what you are doing. Use common sense. Do not operate tool when you are tired. Tools should never be used by you if you are under the influence of alcohol, drugs or medication that makes you drowsy.
22.CHECK DAMAGED PARTS.
Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this Instruction Manual.
Have defective switches replaced by the authorized service center. Do not use tool if switch does not turn it on and off.
5