Husqvarna SG13B manual Set-Up

Page 14

SET-UP

1.Remove crate top and sides.

2.Remove upper handle bar assembly and lay aside.

3.Open bag containing loose hardware.

4.Using four (4) screws, flat washers and nuts attach the upper handle bar assembly to lower handle bar assembly.

NOTE: Handle fit is tight. When aligning holes use a tapered type pilot to help align holes (i.e. punch or phillips style screw driver).

5.Attach the position adjusting rod to bracket on the upper handle bar assembly with the washers and cotter pins placed above the rod bracket. Attach the lower adjustment bar to the unit and secure with cotter pin.

6.Assemble the compression spring, two (2) flat washers and yoke to brake rod assembly.

7.Screw yoke onto the rod assembly until rod is even or through threaded portion of yoke about ¼" (6.35 mm).

UPPER HANDLE BAR
WASHERS	COTTER PINS
ADJUSTING ROD
LOWER
HANDLE BAR
WASHERS
NUT
	SPRING
YOKE

8.Attach brake rod assembly to brake handle on the upper handle bar assembly.

	BRAKE
BRAKE ROD ASSEMBLY	HANDLE
	HUSQVARNA-15

Image 14

Contents Operator Manual Contents Introduction Xxxx xxx xxxx xx xxxx x Decals and machine-mounted instructionsDecal Important information DecalSafety General useSafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Protection equipment Personal Protection EquipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Controls Main Components and ControlsEngine Speed Control LeverFuel Valve StarterStarter Handle Choke ControlMuffler Air FilterSpark Plug Oil Dipstick Oil DrainCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Handle Adjustment Bar BrakeOperation PreparationChoke control Starting The EngineFuel valve ThrottleOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Operating On Hills TransportEmergency Shutdown Engine switchNormal Shutdown BrakeMaintenance Maintenance ScheduleCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Ignition System Fitting the wrong spark plug type can damage the engineDrive Belt Cutting Wheel Left Wheel Brake AdjustmentRemoving/Refitting Wheels Right WheelCleaning Two Minute RuleLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Belt engages late or slips Belt not staying tight after adjustmentBelt comes off Cutting wheel does not rotateService Winter StorageModel SG13B Technical DataDimensions EngineSchematics Service Journal Delivery serviceService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09