Husqvarna SG13B manual Drive Belt

Page 38

MAINTENANCE

Drive Belt

1.Remove the belt guard by removing the three acorn nuts and lockwashers on the front of the belt guard.

WARNING!

Prevent the engine from being started by removing the ignition cable from the spark plug.

8060-226

2.	Check that the belt is properly tensioned by
	squeezing the belt together. It should be possible
	to squeeze the belt down about ¼ - 3/8" (6 - 10
	mm) from the original position.
3.	Loosen screws holding cover plate to belt guard
	backing plate.
	8060-227

4.Undo the two screws (A) on each side of the cutting shroud.

COVER PLATE

SCREWS

8062-006

HUSQVARNA-39

Image 38

Contents Operator Manual Contents Introduction Xxxx xxx xxxx xx xxxx x Decals and machine-mounted instructionsDecal Important information DecalSafety General useSafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Protection equipment Personal Protection EquipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Controls Main Components and ControlsEngine Speed Control LeverFuel Valve StarterStarter Handle Choke ControlMuffler Air FilterSpark Plug Oil Dipstick Oil DrainCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Handle Adjustment Bar BrakeOperation PreparationChoke control Starting The EngineFuel valve ThrottleOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Operating On Hills TransportEmergency Shutdown Engine switchNormal Shutdown BrakeMaintenance Maintenance ScheduleCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Ignition System Fitting the wrong spark plug type can damage the engineDrive Belt Cutting Wheel Left Wheel Brake AdjustmentRemoving/Refitting Wheels Right WheelCleaning Two Minute RuleLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Belt engages late or slips Belt not staying tight after adjustmentBelt comes off Cutting wheel does not rotateService Winter StorageModel SG13B Technical DataDimensions EngineSchematics Service Journal Delivery serviceService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09