Husqvarna SG13B manual Normal Shutdown, Emergency Shutdown, Engine switch, Brake

Page 31

operation

Normal Shutdown

Throttle

Set the throttle to SLOW/DISENGAGE.

If the engine has been running full out, let it run easily for about 30 seconds to 1 minute at low speed.

DO NOT let front of unit touch ground until you are sure cutting wheel has stopped turning.

Engine switch

Wait at least 20 seconds, until the blade has stopped.

Set the toggle switch to OFF.

Make sure that the blade is resting against the ground and has stopped completely before doing anything.

Brake

Activate the brake by pulling the lever backwards.

ON

OFF

Fuel valve

Close the fuel valve. Turn the lever all the way to the left.

Emergency Shutdown

Release the OP grip bar. Wait until the blade stops.

Make sure that the blade is resting against the ground and has stopped completely before continuing.

8060-024

32 - HUSQVARNA

Image 31

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Storage Movement/TransportChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineChoke Control StarterStarter Handle Fuel ValveSpark Plug Air FilterMuffler Oil Drain Oil DipstickFueling Fuel TankCentrifugal Clutch Operator Presence OP Grip Bar Control Panel On/Off Engine SwitchThrottle Brake Handle Adjustment BarPreparation OperationThrottle Starting The EngineFuel valve Choke controlEngine ON/OFF Switch Handle Engine SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsBrake Engine switchNormal Shutdown Emergency ShutdownMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Right Wheel Brake AdjustmentRemoving/Refitting Wheels Left WheelTwo Minute Rule CleaningLubrication Engine Oil Throttle cable Right wheelChecking Engine Oil Level Engine will not start TroubleshootingEngine is weak or runs unevenly Cutting wheel does not rotate Belt not staying tight after adjustmentBelt comes off Belt engages late or slipsWinter Storage ServiceEngine Technical DataDimensions Model SG13BSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09