Husqvarna SG13B manual Starter Handle, Fuel Valve, Choke Control

Page 19

CONTROLS

Starter

The magnapull-type starter has spring return. To replace the return spring or starter cord, contact an authorized service workshop.

IMPORTANT INFORMATION

Do not let the recoil cord snap back by itself. This may damage the cord or the recoil starter assembly.

Starter Handle

 

Misuse of the starter handle can damage the starter.

 

Do not twist the starter cord around your hand.

8011-127

Pull out the handle slowly until the gears mesh. Do not pull out the starter cord completely and do not let go of the starter handle when extended.

Fuel Valve

The fuel valve opens and closes the connection

between the tank and the carburetor. The illustration shows the tank valve closed; to open, turn the lever completely to the right. There is no middle position.

Turn off the valve when the machine is not in use to avoid flooding the carburetor. The fuel valve is combined with a sludge reservoir.

WARNING!

Do not run the engine indoors, in enclosed or poorly ventilated spaces. Engine exhaust fumes contain poisonous carbon monoxide.

Choke Control

The choke control opens and closes the choke valve in the carburetor. This is only used to start a cold engine.

If the engine is warm, the control should be in the far right position.

If the engine is cold, place the lever completely or partly to the left. Move the lever back to the right once the engine starts. Forgetting the choke is evident if the engine runs roughly and produces black smoke.

This also results in increased fuel consumption.

8060-024

8060-024

20 - HUSQVARNA

Image 19
Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Storage Movement/TransportChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineChoke Control StarterStarter Handle Fuel ValveSpark Plug Air FilterMuffler Oil Drain Oil DipstickFueling Fuel TankCentrifugal Clutch Operator Presence OP Grip Bar Control Panel On/Off Engine SwitchThrottle Brake Handle Adjustment BarPreparation OperationThrottle Starting The EngineFuel valve Choke controlEngine ON/OFF Switch Handle Engine SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsBrake Engine switchNormal Shutdown Emergency ShutdownMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Right Wheel Brake AdjustmentRemoving/Refitting Wheels Left WheelTwo Minute Rule CleaningLubrication Engine Oil Throttle cable Right wheelChecking Engine Oil Level Engine will not start TroubleshootingEngine is weak or runs unevenly Cutting wheel does not rotate Belt not staying tight after adjustmentBelt comes off Belt engages late or slipsWinter Storage ServiceEngine Technical DataDimensions Model SG13BSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09