Husqvarna SG13B manual Removing/Refitting Wheels, Brake Adjustment, Left Wheel, Right Wheel

Page 40

MAINTENANCE

Removing/Refitting Wheels

Left Wheel

To remove the left wheel (1) from the stump grinder, remove the locking collar (2), the ¼" screws (3), the ¼" hex nuts (3), the springs (4) and the brake pad (5). The wheel can now be removed from the axle.

Right Wheel

To remove the right wheel (6), remove the locking collar (7) and slide the wheel off the axle.

Brake Adjustment

Overcentering type handle activities brakes.

Undo clevis pin from brake and turn clockwise to tighten brake or counter clockwise to loosen.

Tighten so handle snaps down when locked but unlocks easily when handle is moved forward. Brake is properly adjusted when wheel will not turn when you try to push or pull unit.

6
7
RIGHT
FRONT
3
LEFT
4
5
3
2
1
8011-217
CLEVIS PIN
HAIR PIN
HUSQVARNA-41

Image 40

Contents Operator Manual Contents Introduction Xxxx xxx xxxx xx xxxx x Decals and machine-mounted instructionsDecal Important information DecalSafety General useSafety Preparations Operating Storage Movement/TransportChildren Fuel System Maintenance Protection equipment Personal Protection EquipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Controls Main Components and ControlsEngine Speed Control LeverStarter Starter HandleFuel Valve Choke ControlSpark Plug Air FilterMuffler Oil Dipstick Oil DrainFueling Fuel TankCentrifugal Clutch Operator Presence OP Grip Bar Control Panel On/Off Engine SwitchThrottle Handle Adjustment Bar BrakeOperation PreparationStarting The Engine Fuel valveChoke control ThrottleEngine ON/OFF Switch Handle Engine SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Operating On Hills TransportEngine switch Normal ShutdownEmergency Shutdown BrakeMaintenance Maintenance ScheduleCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Ignition System Fitting the wrong spark plug type can damage the engineDrive Belt Cutting Wheel Brake Adjustment Removing/Refitting WheelsLeft Wheel Right WheelCleaning Two Minute RuleLubrication Engine Oil Throttle cable Right wheelChecking Engine Oil Level Engine will not start TroubleshootingEngine is weak or runs unevenly Belt not staying tight after adjustment Belt comes offBelt engages late or slips Cutting wheel does not rotateService Winter StorageTechnical Data DimensionsModel SG13B EngineSchematics Service Journal Delivery serviceService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09